|
|
|
|
A short video on how to mount stamps on Kling-On Mounting
unmounted rubber stamps. The Mount may be wood, clear acrylic or
some other material The foam or cushion
provides
“ padding” for the stamp so the image prints evenly The rubber die contains the stamp design How to use 1.
Trim the die using a sharp pair of
scissors (some of the stamps are already trimmed) leaving a very small border.
It is important not to undercut the stamp or the design will not print properly. 2.
Cut a piece of
3.
Use a sharp pair of scissors and cut the stamp design out,
leaving a border of a few millimetres. NB it is important NOT to undercut the
die. The cut should slope away from the design, not underneath it Practise on a
corner of the sheet first . It may be better to cut on the left side of the die. 4.
Press the cushion side firmly on a clear acrylic block. The
Kling-On will adhere time and time again to the acrylic block making it easy to
use different designs on the same block. 5.
Stamp your design. Clean your stamp and store on a clear
plastic sheet or holder. We do not recommend prolonged use of acetate sheets or cd cases which have a high content of acetate (acid) to store your stamps on. We recommend that you use Storage boxes or Kling-On Storage sheets which are available from
Samples of an unmounted rubberstamp with Kling-On on an acrylic block
|
|
Manufactured and distributed by The Stamp Connection in the UK Telephone 01795 531860 © Kling-On Cushioning ® 2010 |
